ScanForge 3D tutorials

Step-by-step guides for the tools people ask about most.

These guides cover photo scanning on a 1 mm grid, filling gaps between faces, splitting models into components, parametric templates, the foam ball rotor, adding holes, combining parts and exporting for Bambu Lab printers.

Scan an object on a 1 mm grid

  1. Print or lay down a 1 mm grid mat and put the object in the middle.
  2. Take photos all the way around at the same height, turning the object a little between shots.
  3. Open Scan, add the photos and check the grid status. If no grid is found, type the height.
  4. Type width and length too if you know them; typed values override the grid.
  5. Check the outline previews, then build. Expect pockets to be filled and surfaces to look stepped.

Fill a gap between two faces

  1. Open Tools, then Gap fill.
  2. Tap face A, then face B. They can be on the same part or two parts, in either order.
  3. Check the measured gap, pick Block or Round plug, and choose Slide-in or Fuse.
  4. Place it. One Undo removes it, and History keeps its width, depth and thickness editable.

Split a model into components

  1. Select an imported model and open Split to components.
  2. Tap a component to highlight it and zoom to it.
  3. Tick the boxes on the pieces you don't need, then tap Delete selected and confirm. One Undo restores them.
  4. Use Extract to turn a piece into its own part.

Use a parametric template

  1. Tap Add, then Templates, and pick from Everyday or Blaster cosmetic parts.
  2. Change the fields; values that overlap or break through are flagged.
  3. Place it, then reopen any value from History later.

Build the foam ball rotor

  1. Add the Foam ball rotor template.
  2. Every value from the original script is its own field: chambers, stop, ribs, bore, spring pocket, anchor slot and webs.
  3. Adjust only what your build needs and watch the warnings.
  4. Export as 3MF, or grab the ready-made file from Resources.

Add holes and features to a part

  1. Select a part and open Holes & features.
  2. Tap the face where the hole should go, then type the diameter and depth in millimeters.
  3. Place it. The hole stays in History, so you can change its size later.

Combine or subtract parts

  1. Place the two parts so they overlap.
  2. Open Combine and choose Join, Subtract or Intersect.
  3. Check the result, then use Undo if it isn't what you wanted.

Export a 3MF for Bambu Studio

  1. Tap Export and choose 3MF. Use STL if another slicer needs it.
  2. Open the file in Bambu Studio. Parts arrive Z-up at their real size.
  3. Pick filament, supports and plate, then slice and print from Bambu Studio.